Hello,
I've looked 'high and low' but cannot locate a Speed Decreaser Gear (SDG) to
fit a T58-GE-3 engine. I believe this motor originally flew in a UH-1F Huey.


The SDG needs to be complete, in running condition but does not require
'air-worthy' paperwork (as this for a 'non-aircraft' application) as
detailed here: http://www.weldingfaq.com/turbine2.asp



If you know where I can purchase a Speed Decreaser Gear from (or with) a
T58-GE-3 engine please e-mail me direct at larry <at> skagitmedia <dot> com
(or edit the reply address)



Thanks!
Larry

Did you contact Dakota Air Parts? http://www.dakotaairparts.com

<Larry> wrote in message ...
> Hello,
> I've looked 'high and low' but cannot locate a Speed Decreaser Gear (SDG)
> to
> fit a T58-GE-3 engine. I believe this motor originally flew in a UH-1F
> Huey.
>
>
> The SDG needs to be complete, in running condition but does not require
> 'air-worthy' paperwork (as this for a 'non-aircraft' application) as
> detailed here: http://www.weldingfaq.com/turbine2.asp
>
>
>
> If you know where I can purchase a Speed Decreaser Gear from (or with) a
> T58-GE-3 engine please e-mail me direct at larry <at> skagitmedia <dot>
> com
> (or edit the reply address)
>
>
>
> Thanks!
> Larry
>
>

"Juan Jimenez" > wrote in message
...
> Did you contact Dakota Air Parts? http://www.dakotaairparts.com

I just did- thanks!

Part of the problem is that I've not been able to identify the part number
(as I don't have an Illustrated Parts Breakdown for the UH-1F) and most
folks track parts strictly by part number.

Maybe somebody with a UH-1F pub can scan that illustration and send it to
me?

Thanks!
Larry

larry <at> skagitmedia <dot> com

On Sun, 24 Jul 2005 10:41:36 -0700, Larry wrote:

> "Juan Jimenez" > wrote in message
> ...
>> Did you contact Dakota Air Parts? http://www.dakotaairparts.com
>
> I just did- thanks!
>
> Part of the problem is that I've not been able to identify the part number
> (as I don't have an Illustrated Parts Breakdown for the UH-1F) and most
> folks track parts strictly by part number.
>
> Maybe somebody with a UH-1F pub can scan that illustration and send it to
> me?
>
> Thanks!
> Larry
>
> larry <at> skagitmedia <dot> com

Try contacting Mike Dillon at:

Dillon Precision Products, Inc.
8009 E. Dillons Way
Scottsdale, AZ 85260
(480) 948-8009
http://dillonprecision.com/

Mike is into many endeavors. He makes his money selling reloading presses.
He also produces videos, and manufactures mini-guns for the Navy. His
facility is located on the Scottsdale airport and he owns a small fleet of
unique aircraft, among them a fully airworthy UH-1. He employs at least 2
full time A&Ps.

You may hve to perservere in your attempts to contact him, though I was
treated to a full tour of the facility a few years back just for asking.

Good luck,

Demonick