Last week I found the baffle on our left engine's #6 cylinder had broken the
bracket off the bottom of the baffle. The bracket holds a long skinny
tension/stabilizer rod between the #6 cylinder baffle and the #2 cylinder
baffle.

From what I can tell, the bracket simply needs to be rivited back on to the
baffle, however the baffle will have to be removed to accomplish this. I
have yet to pull the top cowl so I can actually see how the baffle is
attached.

Does anybody have any experience removing this particular baffle? I'm sure
it would have to be removed before the #6 cylinder could be pulled.

Any thoughts are appreciated.

Jim

Get somebody who does a lot of his own maintenance to help you - and
who has some rivets, aluminum, and tools... This is not rocket
science... Easily done with common sense and a little show-n-tell from
others...

denny

Just what I wanted to hear.
Thanks Denny.
Jim

"Denny" > wrote in message
oups.com...
> Get somebody who does a lot of his own maintenance to help you - and
> who has some rivets, aluminum, and tools... This is not rocket
> science... Easily done with common sense and a little show-n-tell from
> others...
>
> denny
>