Prince propeller

[Philippe Vessaire]

Hello,

What about these prop?

May I realy gain a little more airspeed versus ordinary prop?
What gain with carbon fiber?

My airplane: Gardan MiniCab, engine A65.



Thanks
--
MiniCab F-PRAZ
Philippe Vessaire ҿӬ

[Jan Carlsson]

Try GT Propellers at http://www.gt-propellers.com/

Jan Carlsson
www.jcpropellerdesign.com

"Philippe Vessaire" > skrev i meddelandet
-moi...
> Hello,
>
> What about these prop?
>
> May I realy gain a little more airspeed versus ordinary prop?
> What gain with carbon fiber?
>
> My airplane: Gardan MiniCab, engine A65.
>
>
>
> Thanks
> --
> MiniCab F-PRAZ
> Philippe Vessaire ҿӬ
>

[Ken Sandyeggo]

Philippe Vessaire > wrote in message -moi>...
> Hello,
>
> What about these prop?
>
> May I realy gain a little more airspeed versus ordinary prop?
> What gain with carbon fiber?
>
> My airplane: Gardan MiniCab, engine A65.
>
>
>
> Thanks

Philippe, I switched from a Warp to a Prince a few years ago and found
the takeoff-run thrust vastly improved (subjective, but clearly
noticeably improved). Comments from the airport rats confirmed that
the Prince is extremely quiet compared to the Warp. I have the wood
with epoxy coating. Prince can make the epoxy-coated props thinner
and thus more efficient than the plain wood. If Prince is offering
carbon-fiber, I'm sure they will be even more efficient, but I haven't
checked into them. Can't comment on a top-speed increase because in a
gyro that's not too much of a concern. I have no financial interest
in Prince props, so my post is totally spam-free. From what I read,
Prince has an excellent reputation and fine product. I am very
satisfied with mine.

Ken J. - Sandy Eggo

[Morgans]

"Ken Sandyeggo" > wrote in message
om...
> Philippe Vessaire > wrote in message
-moi>...
> > Hello,
> >
> > What about these prop?
> >
> > May I realy gain a little more airspeed versus ordinary prop?
> > What gain with carbon fiber?
> >
> > My airplane: Gardan MiniCab, engine A65.
> >
> >
> >
> > Thanks
>
> Philippe, I switched from a Warp to a Prince a few years ago and found
> the takeoff-run thrust vastly improved (subjective, but clearly
> noticeably improved). Comments from the airport rats confirmed that
> the Prince is extremely quiet compared to the Warp. I have the wood
> with epoxy coating. Prince can make the epoxy-coated props thinner
> and thus more efficient than the plain wood. If Prince is offering
> carbon-fiber, I'm sure they will be even more efficient, but I haven't
> checked into them. Can't comment on a top-speed increase because in a
> gyro that's not too much of a concern. I have no financial interest
> in Prince props, so my post is totally spam-free. From what I read,
> Prince has an excellent reputation and fine product. I am very
> satisfied with mine.
>
> Ken J. - Sandy Eggo

And made in the small hometown I grew up in. I have looked at the address,
but cant figure out where they are located. It has been a number of years
since I have been back. Anyone here ever been to the factory?
--
Jim in NC