Martin Morgan
November 23rd 03, 11:08 PM
I'm wanting to lay my seat back further in an existing pitts S1-S. This
would require moving the tube at the top of the seat back, back about
2". This member is 3/4 x 0.035 and about 22" long.
I was thinking to run 4" long gussets back to the original attachment
point, creating a C shaped section.
The problem is that the center of the tube now dosen't line up with the
centerlines of the other tubes at the cluster. I know this has been done
before but I have no idea how to work out the size needed for the new tube.
Does anyone have experience with this?
Regards
Martin Morgan
would require moving the tube at the top of the seat back, back about
2". This member is 3/4 x 0.035 and about 22" long.
I was thinking to run 4" long gussets back to the original attachment
point, creating a C shaped section.
The problem is that the center of the tube now dosen't line up with the
centerlines of the other tubes at the cluster. I know this has been done
before but I have no idea how to work out the size needed for the new tube.
Does anyone have experience with this?
Regards
Martin Morgan