LS-8 outer ballast tank filler thingie

[Tuno]

The outer ballast tanks use a fitting what I don't have. Is there an
off the shelf workaround?

tuN7o

[Papa3]

For the outers, yes. I don't have mine in front of me, but it's just a rigid plastic fitting of thick walled pipe. It has a slight taper iirc, but it is a friction fit. A length of PVC with the right od would work.

[Peter Wyld[_2_]]

At 01:05 03 September 2011, Tuno wrote:
>The outer ballast tanks use a fitting what I don't have. Is there an
>off the shelf workaround?
>
>tuN7o
>

probably not, it's a tapered tube - the taper end is rammed into the hole
in the wing and suitable supply of water applied to the other end.

Find someone who has one and turn down a suitable thick walled tube to
match the taper.

[vaughn[_3_]]

"Peter Wyld" > wrote in message
. com...
> probably not, it's a tapered tube - the taper end is rammed into the hole
> in the wing and suitable supply of water applied to the other end.
>
> Find someone who has one and turn down a suitable thick walled tube to
> match the taper.

Schedule 80 PVC pipe or electrical conduit of an appropriate diameter would
likely be a good material to make that from. It may not be a retail item, but
is redily available at a wholesale plumbing or electrical supply.

Alternatively, you might get lucky enough that the bell end cut from a length of
ordinary PVC pipe would serve.

Vaughn

[bumper[_4_]]

On Sep 2, 6:05*pm, Tuno > wrote:
> The outer ballast tanks use a fitting what I don't have. Is there an
> off the shelf workaround?
>
> tuN7o

If you are around Minden I can probably make you one if I have either
the plane or fitting to look at. . . Or a diagram.

Bumper