Tail dolly for 1-35?

[[email protected]]

Hello all - I've decided that I need to build a tail dolly for my 1-35. It occurs to me that maybe someone has one they'd sell and that would save me the trouble...? One from a 1-34 would likely also fit...

[Paul Remde]

Hi,

Is there any chance that the tail dolly shown in the link below is for a
1-35?
https://www.facebook.com/media/set/?set=a.501806009900033.1073741827.363734733707162&type=3

Best Regards,

Paul Remde
_____________________________

wrote in message
...

Hello all - I've decided that I need to build a tail dolly for my 1-35. It
occurs to me that maybe someone has one they'd sell and that would save me
the trouble...? One from a 1-34 would likely also fit...

[[email protected]]

On Saturday, September 21, 2013 1:53:38 PM UTC-4, wrote:
> Hello all - I've decided that I need to build a tail dolly for my 1-35. It occurs to me that maybe someone has one they'd sell and that would save me the trouble...? One from a 1-34 would likely also fit...

Dear Paul - could be? My ship is about 200 miles away, may see in a few days. I know that the width of the fuselage right about the front of the vertical stab is 7.25" - let me know if that's a match, and the height of the cross-section at that point on your dolly...and what you'd want for it.

Reply in private if you like.

[[email protected]]

On Saturday, September 21, 2013 1:53:38 PM UTC-4, wrote:
> Hello all - I've decided that I need to build a tail dolly for my 1-35. It occurs to me that maybe someone has one they'd sell and that would save me the trouble...? One from a 1-34 would likely also fit...

My club has a 1-35 tail dolly/wheel that has been languishing at the club since the owner wrecked his 1-35 years ago and donated the carcass to the club. Let me take a couple of pics if it is still around and see if the BoD will sell it. Actually not doing us any good. but, I'm not on the BoD.

as I remember, this tail dolly lock onto the tail wheel spring.

r/Jim

[[email protected][_2_]]

You can find a photo of the tail dolly that I made for my 1-35 on the 1-35 website. It looks very similar to the mystery dolly referred to by Paul Remde.

Raul Boerner


http://members.goldengate.net/~tmrent/soar/docs/135/SGS%20-%20hinge%20and%20tail%20dolly.JPG

[[email protected]]

On Saturday, September 21, 2013 1:53:38 PM UTC-4, wrote:
> Hello all - I've decided that I need to build a tail dolly for my 1-35. It occurs to me that maybe someone has one they'd sell and that would save me the trouble...? One from a 1-34 would likely also fit...

Thanks, everyone - especially Paul Remde! His mystery hangar flotsam turned out to be a perfect fit, and quite clean and well-made. What service!