Size of Allen Wrench used to secure horizontal of ASG-29

[Jonathan St. Cloud]

Anyone know the size of allen wrench used to secure the horizontal of an ASG-29?

[James Lambert]

At 20:49 30 October 2016, Jonathan St. Cloud wrote:
>Anyone know the size of allen wrench used to secure the horizontal of an
>ASG-29?
>I just reach for my set of ball ended hex keys, metric..... I'm fairly
sure there are other sizes somewhere around the machine, and if you have a
sensible tool set you might become much sought after...

[Tom Kelley #711]

On Sunday, October 30, 2016 at 2:49:28 PM UTC-6, Jonathan St. Cloud wrote:
> Anyone know the size of allen wrench used to secure the horizontal of an ASG-29?

Just checked my tool for the horizontal and its a 8 MM hex.

Best. Tom. #711.

[Jonathan St. Cloud]

Thank you much!

On Sunday, October 30, 2016 at 3:44:48 PM UTC-7, Tom Kelley #711 wrote:
> On Sunday, October 30, 2016 at 2:49:28 PM UTC-6, Jonathan St. Cloud wrote:
> > Anyone know the size of allen wrench used to secure the horizontal of an ASG-29?
>
> Just checked my tool for the horizontal and its a 8 MM hex.
>
> Best. Tom. #711.

[George Haeh]

Buy a half dozen from your favorite made in China supplier and
top up every spring.

[Dave Nadler]

On Sunday, October 30, 2016 at 4:49:28 PM UTC-4, Jonathan St. Cloud wrote:
> Anyone know the size of allen wrench used to secure the horizontal of an ASG-29?

Aw, just find the old one:
Turn the glider upside-down and give it a good shake.