Flarm/ClearNav Help Needed

[Dan Marotta]

Hi All,

I built a cable for My Power FLARM portable according to the drawing on
the Tech Tips portion of the ClearNav site but The CN does not connect
to the Flarm. I have a cable tester and the cable checks good. I've
tried baud rates from 19.2 to 57.6K and still no luck.

I also spoke with another CNII user at Moriarty and he asked me if I'd
enabled FLARM on my CNII. I've looked and can't find anything other
than Flarm Status - There is none, and Flarm Alerts and I have the
longest alerts selected.

What about the Flarm dataport strings? Flarm Only or Flarm and Nav
(I've tried it both ways without success)? Does anyone have any other
suggestions?

--
Dan, 5J

[RW[_2_]]

On Tuesday, December 20, 2016 at 7:48:11 PM UTC-5, Dan Marotta wrote:
> Hi All,
>
> I built a cable for My Power FLARM portable according to the drawing on
> the Tech Tips portion of the ClearNav site but The CN does not connect
> to the Flarm. I have a cable tester and the cable checks good. I've
> tried baud rates from 19.2 to 57.6K and still no luck.
>
> I also spoke with another CNII user at Moriarty and he asked me if I'd
> enabled FLARM on my CNII. I've looked and can't find anything other
> than Flarm Status - There is none, and Flarm Alerts and I have the
> longest alerts selected.
>
> What about the Flarm dataport strings? Flarm Only or Flarm and Nav
> (I've tried it both ways without success)? Does anyone have any other
> suggestions?
>
> --
> Dan, 5J

Power Flarm has to finish power up dance before you start CN.
Ryszard

[JS]

On Tuesday, December 20, 2016 at 5:25:16 PM UTC-8, RW wrote:
> On Tuesday, December 20, 2016 at 7:48:11 PM UTC-5, Dan Marotta wrote:
> > Hi All,
> >
> > I built a cable for My Power FLARM portable according to the drawing on
> > the Tech Tips portion of the ClearNav site but The CN does not connect
> > to the Flarm. I have a cable tester and the cable checks good. I've
> > tried baud rates from 19.2 to 57.6K and still no luck.
> >
> > I also spoke with another CNII user at Moriarty and he asked me if I'd
> > enabled FLARM on my CNII. I've looked and can't find anything other
> > than Flarm Status - There is none, and Flarm Alerts and I have the
> > longest alerts selected.
> >
> > What about the Flarm dataport strings? Flarm Only or Flarm and Nav
> > (I've tried it both ways without success)? Does anyone have any other
> > suggestions?
> >
> > --
> > Dan, 5J
>
> Power Flarm has to finish power up dance before you start CN.
> Ryszard

Also the higher the baud rate, the longer the connection process. The CN2 starts looking at low rates then goes higher.
Jim

[Tango Eight]

Dan -- pls check the forum.

Thx

Evan