flarm/oudie

[[email protected]]

Hi
I am in the process of acquiring a flarm.

Today I connected a friend portable flarm to my Oudie 2 to
visualize the result on a oudie screen,
and to evaluate if I need another display.
Not welcome on my small LS6 panel.
The problem; the oudie says it is connected and receiving the signal
but noting appears on the screen.
Advice welcome.
Thank you
Gilles

[Richard Pfiffner[_2_]]

On Thursday, September 14, 2017 at 5:15:26 PM UTC-7, wrote:
> Hi
> I am in the process of acquiring a flarm.
>
> Today I connected a friend portable flarm to my Oudie 2 to
> visualize the result on a oudie screen,
> and to evaluate if I need another display.
> Not welcome on my small LS6 panel.
> The problem; the oudie says it is connected and receiving the signal
> but noting appears on the screen.
> Advice welcome.
> Thank you
> Gilles

Giles

Oudie

Menu Settings Radar set to "always"

Range marks and flarm targets should show on the main map screen.

If you Menu setting Radar is set to 2 miles you only see flarm on screen zoom of 2 miles or less. Most fly with a default zoom level on the main screen much higher.

I have PowerFlarm Cores in stock and a variety of antennas.

http://www.craggyaero.com/powerflarm_core1.htm

Richard
www.craggyaero.com

[[email protected]]

Le jeudi 14 septembre 2017 20:15:26 UTC-4, a écritÂ*:
> Hi
> I am in the process of acquiring a flarm.
>
> Today I connected a friend portable flarm to my Oudie 2 to
> visualize the result on a oudie screen,
> and to evaluate if I need another display.
> Not welcome on my small LS6 panel.
> The problem; the oudie says it is connected and receiving the signal
> but noting appears on the screen.
> Advice welcome.
> Thank you
> Gilles

Thank you Richard
A second flarm was on about 20 meters away with range set to 35 km.
I have to check "always"
Gilles

[Nick Hill[_3_]]

On 15/09/2017 01:15, wrote:
> Hi
> I am in the process of acquiring a flarm.
>
> Today I connected a friend portable flarm to my Oudie 2 to
> visualize the result on a oudie screen,
> and to evaluate if I need another display.
> Not welcome on my small LS6 panel.
> The problem; the oudie says it is connected and receiving the signal
> but noting appears on the screen.
> Advice welcome.
> Thank you
> Gilles
>

Was the baud rate at or above 19200? If not then GPS data will be
transmitted such the device may be reported as connected but without the
Flarm data sentences

--

Nick Hill