CAD drawing DG-100/101 instrument panel

[Senna Van den Bosch]

Hi everyone, I would like to do my instrument panel again since I have to fit a transponder somewhere.

Does anyone have the correct outlines? In CAD maybe? I have found this link: https://www.dg-flugzeugbau.de/Data/instrument-panel.zip which appears to be dead by now.

Any help is appreciated!

[z[_2_]]

On Friday, October 12, 2018 at 7:55:16 AM UTC-6, Senna Van den Bosch wrote:
> Hi everyone, I would like to do my instrument panel again since I have to fit a transponder somewhere.
>
> Does anyone have the correct outlines? In CAD maybe? I have found this link: https://www.dg-flugzeugbau.de/Data/instrument-panel.zip which appears to be dead by now.
>
> Any help is appreciated!

I have a CAD drawing for a DG-600. I do not know if it is the same as a -100/101.

[AS]

On Friday, October 12, 2018 at 9:55:16 AM UTC-4, Senna Van den Bosch wrote:
> Hi everyone, I would like to do my instrument panel again since I have to fit a transponder somewhere.
>
> Does anyone have the correct outlines? In CAD maybe? I have found this link: https://www.dg-flugzeugbau.de/Data/instrument-panel.zip which appears to be dead by now.
>
> Any help is appreciated!

Hi Senna,

try here under 'Bretter': http://martinkopplow.de/Instrumente/Segelfliegers_Einrichtungshaus/Home.html

Good luck,

Uli
'AS'

[SF]

Trace the existing panel on drawing paper. Scan it, import it cad. Trace over the top of it. Scale it to size.