PIK20D Control surface hinge moments

[PIK20D]

Dear All,
Anybody could help me where can I find the correct values of PIK20D
control surface hinge moments for rudder, elevator, aileron, flaps ?
Need to know after repainting these for checking.

[WDM]

Try ... http://www.gliding.co.uk/bgainfo/technical/datasheets.htm

PIK20D wrote:
> Dear All,
> Anybody could help me where can I find the correct values of PIK20D
> control surface hinge moments for rudder, elevator, aileron, flaps ?
> Need to know after repainting these for checking.

[PIK20D]

Thanks, but I would like to know the HINGE MOMENTS, I know the
deflections very well from the manual.

> Try ... http://www.gliding.co.uk/bgainfo/technical/datasheets.htm
>
> PIK20D wrote:
> > Dear All,
> > Anybody could help me where can I find the correct values of PIK20D
> > control surface hinge moments for rudder, elevator, aileron, flaps ?
> > Need to know after repainting these for checking.

[Derrick Steed]

Istvar,

I have contacted the person I knew (he is a long established glider repairer here in the UK).

From his PIK20D Flight/repair manual, repair section page 3 section 9 "Balancing of control surfaces":

This measurement from the hinge line:

Aeleron: 29mm

Flap: 35mm

Rudder: 20 mm

The idea is to balance the surface on that measurement (no tolerances given, but he says Schleicher work on about 10-15%)

For the Elevator the moment should be less than 40g/mm from the hinge line.

Hope this helps.

Rgds,

Derrick Steed