Looking for 1" or 25mm OD carbon fiber tubing

[Bill Daniels]

For winglet attachment. Any favorite sources?

Bill Daniels

[[email protected]]

http://www.kitebuilder.com/inventory/rwgcarbon.htm

Not all of the tube sold has the outer wrap for hoop strength.
==============
Leon McAtee

[Bill Daniels]

> wrote in message
ups.com...
> http://www.kitebuilder.com/inventory/rwgcarbon.htm
>
> Not all of the tube sold has the outer wrap for hoop strength.
> ==============
> Leon McAtee
>
Nice 1" ID tubing but I need 25mm or .995" or so OD to slip inside 1" ID.

Bill Daniels

[Smitty Two]

In article >,
"Bill Daniels" > wrote:

> > wrote in message
> ups.com...
> > http://www.kitebuilder.com/inventory/rwgcarbon.htm
> >
> > Not all of the tube sold has the outer wrap for hoop strength.
> > ==============
> > Leon McAtee
> >
> Nice 1" ID tubing but I need 25mm or .995" or so OD to slip inside 1" ID.
>
> Bill Daniels

I just googled "carbon fiber tubes stock sizes" (without quotes) and the
first hit was

http://carbonfibretubes.co.uk/

which I realize is in the UK, but they list a 25mm OD as a standard. If
they have them, someone else does too.

[[email protected]]

>>Nice 1" ID tubing but I need 25mm or .995" or so OD to slip inside 1" ID.

Bill Daniels <<

Sorry about that I didn't look close enough at the OD/ID. Maybe the
..820 OD could be wraped where needed with another layer of glass and
sanded to fit?

If not check directly with:

http://www.aviasport.net/index.htm

If they don't have it they can make it - if you buy enough:-)
================
Leon McAtee