Tom Gibson
March 9th 06, 06:28 PM
Hi,
I have this problem if I load the airport too soon to the scheduled
arrival of the plane. If it's too close to the airport when loaded, the
plane will just keep on goin....
Hope this helps,
Tom Gibson
Cal Classic Propliner Page: http://www.calclassic.com
Cal Classic Alco Page: http://www.calclassic.com/alco
Freeflight Design Shop: http://www.freeflightdesign.com
CM wrote:
> Hey what do you guys think is wrong here? :
> I have a DC-10 (the Evolve model) that refuses to descend any lower than FL
> 260 for landing at PHNL. It maintains this altitude and coast off the
> scope at 470 kts, never even slowing. It's not the plane because this same
> plane lands just fine at 3 other airports. It's not the airport because
> every other one of my many AI planes seem to land there with no problem.
> There is a United DC-10 that descends and lands just perfectly and it uses
> the exact same flight model. The flight is KLAX-PHNL and should be a
> no-brainer. It seems like it's losing touch with ATC at some point and just
> gets lost. Any ideas?
> Thanks
I have this problem if I load the airport too soon to the scheduled
arrival of the plane. If it's too close to the airport when loaded, the
plane will just keep on goin....
Hope this helps,
Tom Gibson
Cal Classic Propliner Page: http://www.calclassic.com
Cal Classic Alco Page: http://www.calclassic.com/alco
Freeflight Design Shop: http://www.freeflightdesign.com
CM wrote:
> Hey what do you guys think is wrong here? :
> I have a DC-10 (the Evolve model) that refuses to descend any lower than FL
> 260 for landing at PHNL. It maintains this altitude and coast off the
> scope at 470 kts, never even slowing. It's not the plane because this same
> plane lands just fine at 3 other airports. It's not the airport because
> every other one of my many AI planes seem to land there with no problem.
> There is a United DC-10 that descends and lands just perfectly and it uses
> the exact same flight model. The flight is KLAX-PHNL and should be a
> no-brainer. It seems like it's losing touch with ATC at some point and just
> gets lost. Any ideas?
> Thanks