Taper pin or telephone No.

[Fred[_1_]]

We're looking to replace 4 taper pins for an LP-49. If I measured
right, they are an AN386-9-28A and we need 4. Aircraft Spruce says
they do not have them.

Alternatively, we need Jack Laister's phone no.

Can anyone help on this? Thanks. Fred

[Bob Kuykendall]

Earlier, "Fred" > wrote:

> We're looking to replace 4 taper pins for an LP-49.

> If I measured right, they are an AN386-9-28A and we
> need 4. Aircraft Spruce says they do not have them.

Those are honkin' huge AN386s. I'm going to guess that they're the
main wing pins at the center section, and you're just going to cut off
the threaded portion at the tip.

You may be able to get them from a mil-spec hardware house; ACS is not
the only game in town.

You also may be able to have them custom made at a machine shop or
grinding shop.

Also, sometimes I find that the AN386 I need isn't available, but a
longer one of the same tip diameter is. I just buy the longer pin,
chuck it in the lathe, and cut or grind off the unneeded portion.

> Alternatively, we need Jack Laister's phone no.

Unfortunately, Jack passed away a few months ago, so that's likely to
do much good.

Thanks, and best regards to all

Bob K.
http://www.hpaircraft.com

[Ian Cant]

'Fred' wrote:
>
>> We're looking to replace 4 taper pins for an LP-49.
>>
>
>> If I measured right, they are an AN386-9-28A and we
>> need . Aircraft Spruce says they do not have them.
>

Google 'taper pin AN3864', it gives a number of suppliers
and mfgrs

Ian

[Ian Cant]

'Fred' wrote:
>
>> We're looking to replace 4 taper pins for an LP-49.
>>
>
>> If I measured right, they are an AN386-9-28A and we
>> need . Aircraft Spruce says they do not have them.
>

Google 'taper pin AN386', it gives a number of suppliers
and mfgrs

Ian

[raulb]

Jack Laister died last November.

Fred wrote:

> Alternatively, we need Jack Laister's phone no.
>
> Can anyone help on this? Thanks. Fred