taper pins

[Ernest Christley]

What has happened to taper pins? I need two AN386-3-9A pins to tie a
universal joint to a one inch torque tube. AS&S says that I've got to
buy 5 at 17.50(USD) each.

Can anyone recommend a source that actually wants to sell them at a
reasonable price?

--
----Because I can----
http://www.ernest.isa-geek.org/
------------------------

[Jerry Wass]

Lemmie look, I gotta bunch--Jerry--also the reamers-(only one each)

Ernest Christley wrote:

> What has happened to taper pins? I need two AN386-3-9A pins to tie a
> universal joint to a one inch torque tube. AS&S says that I've got to
> buy 5 at 17.50(USD) each.
>
> Can anyone recommend a source that actually wants to sell them at a
> reasonable price?
>
> --
> ----Because I can----
> http://www.ernest.isa-geek.org/
> ------------------------

[Jerry Wass]

Nope, Sorry, got some 1-9's & some 2-14-a's

Ernest Christley wrote:

> What has happened to taper pins? I need two AN386-3-9A pins to tie a
> universal joint to a one inch torque tube. AS&S says that I've got to
> buy 5 at 17.50(USD) each.
>
> Can anyone recommend a source that actually wants to sell them at a
> reasonable price?
>
> --
> ----Because I can----
> http://www.ernest.isa-geek.org/
> ------------------------

[Corrie]

Ernest Christley > wrote in message >...
> What has happened to taper pins? I need two AN386-3-9A pins to tie a
> universal joint to a one inch torque tube. AS&S says that I've got to
> buy 5 at 17.50(USD) each.
>
> Can anyone recommend a source that actually wants to sell them at a
> reasonable price?

Try ebay? This listing is for 4-27s, but who knows what will show up
next week? http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=26439&item=2431553561

[Ryan Young]

You might think about using standard taper pins, used in machinery. Several
local hardware stores around here stock them, in a variety of sizes. NOTE:
they use a different taper than the AN jabbados. And you'd have to figure
out how to retain them yourself.

But typically they run from .60 to mebbe 3 bucks each, depending on size.

For an experimental, of course.
--
Ryan R Young
Oakland, CA
http://users.lmi.net/~ryoung

> From: Ernest Christley >
> Organization: Road Runner - NC
> Newsgroups: rec.aviation.homebuilt
> Date: Wed, 10 Sep 2003 13:36:12 GMT
> Subject: taper pins
>
> What has happened to taper pins? I need two AN386-3-9A pins to tie a
> universal joint to a one inch torque tube. AS&S says that I've got to
> buy 5 at 17.50(USD) each.
>
> Can anyone recommend a source that actually wants to sell them at a
> reasonable price?
>
> --
> ----Because I can----
> http://www.ernest.isa-geek.org/
> ------------------------
>