Have a cessna 150 with 150 HP conversion. I burn regular mogas for the most part. My bird can tanker up to 60 gallons so I have very long range capability. The plane runs fine on the mogas not to mention the SAVINGS! Avgas here is running as much as 5 bucks a gallon! car gas runs about...

I lurk here off and on, but I found something the other day that I thought you builders might get a chuckle from. Many of you are probably familiar with Lindsay Press. They dredge up old how-to books from the early days and reprint them. I was at a local technical bookstore today, and found a...

http://tinyurl.com/24og9o Read about the bewildering details of a number of long-suffering non-resident pilots who have been caught in the FL tax trap, (otherwise known as the "Florida Landing Fee"). It starts like this... you buy a new or used aircraft and sign the bill of sale... which starts...

http://tinyurl.com/2vwes4 by Harry Dacre, 1892 There is a flower Within my heart, Daisy, Daisy! Planted one day By a glancing dart,

This got me thinking, a rudderless Ercoupe in a multi-directional wind landing...... http://www.youtube.com/watch?v=7l2NJFrvYls Do you (I) really want a home that close to a GA landing strip? Yet I see megabuck homes in my neck of the woods http://www.visualtour.com/shownp.asp?prt=85&t=1217861

Does any one have a manual showing the pin outs for the turn and bank? I need to wire it into my panel. Thanks

Does anyone know if HAPI made an accessory case with the starter in the top position?

Can someone point me on how to build a fiberglass fuel tank and use aluminum fittings? Thanks Bill

"Gerrie" wrote in message ... On Sun, 17 Aug 2003 12:02:40 GMT, (Gerrie) wrote: http://www.baragwanath.netfirms.com/missions/airstrip.htm/ Sorry, I screwed up, the correct URL is

Is anyone aware of statistical or other data that would indicate what percentage of engines make it well beyond the factory specified TBO, and how much longer they can be flown safely? I worry about sudden engine failure due to metal fatigue. Many of the small Lyc. engines have a TBO of around...

You might want to also check out gyroplanes. NZ has a new one that is top of the line. There's a few good websites about them: http://www.aero-sport.com/ http://www.gyroplane.ca http://classics.nu/pitbull/pitbull.html John Burns wrote: Hi there

I heard on the radio that a small plane from Chicago went missing in the fog during a landing attempt at the Toronto City Centre Airport. This morning I see in the newspaper that the plane and the pilot have been located at the bottom of Lake Ontario. The plane was a Beechcraft that could seat six...

I know it was a car, but it looked like a jet trainer body, riding on three wheels. It was around in 1981 or so. Had a Subaru twin cylinder engine rated at 100 mpg.

Hi guys , does anybody know which is the best place , if any , to get large 3 by 12 foot 4130 annealed sheets in 0.100 , 0.063 , 0.032 ? I need about 600 pound . Steve Australia ( thats why I need so much , we got nothing here exept crocodiles.)

Hello everyone, I'm back in the shop again with a new problem. That is, how to drill accurate holes on-center through steel tubing. I need to attach 2 short lengths of 1/2" EMT tubing parallel to the top tube of a bicycle frame, one on each side. The EMT tubes will extend about 20" forward of...

Anyone have a good (ie cheap) source for SS cable, thimbles, and sweges? This is for a non-aviation project so strength specs aren't an issue, as long as its SS (or looks like SS to my roommate). The intended useage is in the rails of the deck I've been attempting to finish for months. Yes, its...

This will be an odd request since solid-strand spring steel wire hasn't been used in a/c for nearly 80 years. Here goes: I'm using 15ga. solid-strand spring steel wire in my Wright 1902 glider. It was shipped with an oil-coating that held up for a few months. Problem is that the oil did not...

Last Saturday an FM2 (?) Wildcat was lost on final approach to Ellington Field in Houston following the airshow. One fatality. I did not see the crash, but watched his departure from the ramp. If anyone has any more info. on this accident, please e-mail me. Thank you, Harry Frey Wright Brothers...

Midair over north Boulder, CO today with three confirmed fatalities so far. A Piper Pawnee towing what I believe is a Lockheed glider was struck by a Cirrus SR-20 northwest of the Boulder County airport. The glider was able to release and return safely to the gliderport. The SR-20 appears to have...

On Sep 13, 4:10*pm, " wrote: Howdy, Any comments or recommendations? *What rigs have you used for aircraft welding, and were they worth the price compared to the others? Anyone had safety issues with the cheap torch sets off Ebay? Thanks in...