|
|
cost to install engine analyzer (4 cyl)? by
dlevy
Anyone had a 4 cylinder engine analyzer installed lately? I'm thinking
about an EDM-700 on a Lycoming O-320-E2C in a Beech Musketeer and was
wondering about install costs.
( 1 2 3)
|
|
25 |
2,358 |
|
|
C-182 or C-1820RG, or C-210.... by
[email protected]
I'm thinking of buying a 182 or 182 RG.
I like cessnas and the 182 is such an honest airplane it's hard to beat.
I'd just like it to be a bit faster.
If all of the speed mods are done to a normal C-182 , Good wheel pants, speed fairings, gap seals etc.....
how fast is it?
For comparision how...
( 1 2 3)
|
December 8th 03 03:29 AM
by Newps
|
22 |
2,355 |
|
|
|
|
14 |
2,355 |
|
|
FS: Bendix/King Skymap IIIC Color GPS by
NW_Pilot
Selling my Skymap IIIC GPS because I am needing funds for upgrading to
another make and model of GPS/EFB!
I have used this unit and is in almost New condition (Normal Scratches)
works great but it is time for me to upgrade to an electronic Flight Bag
type GPS.
Retails New For $2,279.00...
|
|
0 |
2,355 |
|
|
|
|
48 |
2,354 |
|
|
|
|
13 |
2,353 |
|
|
Softcomm panel mount intercom? Junk? by
[email protected]
I'm in the market for a 4 place panel mount, stereo intercom and am
looking at options. I understand installation is going to cost more
than the intercom so am thinking that a prewired harness would be a
good thing. Would really like to put in a PS Engineering or NAT
Intermusic, but by the time I...
( 1 2)
|
November 26th 05 06:46 AM
by spyfly
|
10 |
2,352 |
|
|
Reflections on a year of aircraft ownership by
Ross
brian whatcott wrote:
Mike Ash wrote:
So far I do not regret my decision to purchase in the least. /snip/
Money wasn't a worry to me, but it's still something I thought about.
So far, so good. I put 55.4 hours on it over the past year /snip/
All in all, it's been a great...
|
December 7th 09 06:16 PM
by Ross
|
0 |
2,349 |
|
|
Engine preheater on ebay?? by
skym
There's a portable engine preheater on ebay motors for $129. It looks
like an ok unit but I'm asking for any of the collective wisdom on pros
or cons of a unit like this. There's also one on Sportys for $399.
Any opinions on either or a comparison?
( 1 2 3)
|
|
20 |
2,348 |
|
|
Piper 235 tail skin by
Ross
Jay and other owners of this aircraft. Any documentation on cracks
forming on the horizontal tail surfaces. The -235 I am helping on annual
had three additional cracks in the skin beyound the two that were
repaired by the previous owner. Got some old skin and made conforming
patches.
--...
( 1 2 3)
|
|
26 |
2,345 |
|
|
CHEAP Los Angeles C-172 Flying Club CHEAP by
[email protected]
On Mar 26, 6:18*pm, wrote:
The older 172's with manual flaps and
simple basic electronics are pretty low maintenance.
Nope. Unless someone has already replaced a lot of stuff like control
cables, pulleys, control surface hinges and many other things, these
will all be pretty...
|
|
1 |
2,344 |
|
|
stall strips ??? by
Tri-Pacer
I've noticed stall strips installed on a number of low wing aircraft.
However I've never noticed them installed on a high wing.
How come? Is there something inherent in the design of a high wing that
insures the stall starts at the wing root?
Or perhaps they're out there and I've just not...
|
December 8th 06 06:18 PM
by jls
|
6 |
2,342 |
|
|
Pirep on replacing interior plastic parts by
[email protected]
A recent post bemoaned the high cost of replacement interior plastic parts
from the original manufacturer (in this case, Cessna). I suggested that
parts of this type are available, often at lower cost, from PMA sources.
This led to a discussion of relative merits of original vs. PMA,...
|
|
1 |
2,341 |
|
|
ILS approach to near minimums - Video by
A Lieberma[_2_]
First time for me going down to near ILS minimums by myself. Video
includes how I brief my IFR approaches.
http://www.youtube.com/watch?v=NCk_RRMemnM
Video I think does a good job on demonstrating why the runway may not
be always exactly in front of you after wind correction angle
considerations...
|
|
0 |
2,341 |
|
|
Acro Sport Project for sale by
Frank P. Janner
I have an Acro Sport 2 project for sale. Fus. complete. wings 90% tail
feathers all welded. Have all flying and landing wires. many more
bearings and parts. Very good workmenship. No time to finnish Sanford
Mi. (989) 687-5014 Frank
*** Sent via http://www.automationtools.com ***
Add a...
|
|
0 |
2,340 |
|
|
Online source for oil filters? by
Ben Smith
For those that aero-shop online, where do you order your oil filters from?
It's time for me to stock up again... (I use CH48110's) TIA,
--
Ben
C-172 - N13258 @ 87Y
( 1 2 3)
|
|
23 |
2,334 |
|
|
Narco MK 12 D+ by
Tri-Pacer
I have a Narco MK-12D+ that has an intermittent connection in the display
assembly. At times the display will go dim---it never goes completely
out-----. Pressing lightly anywhere on the front panel returns it to normal
brilliance.
This pretty well isolates the problem to either the display...
|
|
2 |
2,334 |
|
|
Seat belt tags by
Stephen Stilkey
Just finished the annual inspection on my 1963 172 this afternoon. It was
the first time I had used this A+P to inspect my plane. I assisted and
things went smoothly. It's interesting that a "new" set of eyes can see
things that have been overlooked in the past. Anyway, the seat belts no
longer...
( 1 2 3)
|
|
28 |
2,333 |
|
|
Bendix King GPS Updates by
Matthew Waugh
I'm looking for information, feedback, pitfalls of updating Bendix-King
GPS's such as the KLN-89B and KLN-94 by updating the cards directly as
opposed to plugging into the GPS itself. I understand that there is a card
reader you can buy and that there is a firmware upgrade to it that allows
the...
|
|
1 |
2,333 |
|
|
Vibration Testing by
Jim Weir
I've come across a marvelously cheap vibration sensor that I want to convert
into an engine vibration instrument for a Kitplanes article. The electronics
for me is relatively trivial...the mechanics of vibration are a little harder to
fathom.
From a mechanical engineering point of view on a...
( 1 2 3)
|
|
21 |
2,331 |