|
|
AOPA financial support for Bush? by
Mike Noel
A pilot friend mentioned an alleged conversation he had with Phil Boyer, the
president of AOPA. Supposedly he asked if the AOPA would support either
presidential candidate and was told that AOPA had already supported George W
Bush through political contributions. I can find nothing to back up...
( 1 2)
|
October 1st 04 04:37 PM
by xyzzy
|
18 |
1,447 |
|
|
Skycraft Landing Light Installation Pix by
Jay Honeck
http://www.alexisparkinn.com/skycraft_landing_lights.htm
The pictures don't capture all the nitty gritty details of the
installation. A couple of things to note:
1. The wiring does NOT go inside the wings, but is rather routed inside
a flexible conduit that gets attached to the wing ahead of the...
|
|
5 |
1,446 |
|
|
Repairing Plastic by
Jay Honeck
The faceplate on my Narco CP-136 Audio Panel was broken off (and glued back
together) before I bought the plane. The left side of the faceplate, where 2
retaining screws attach it to the metal chassis, had been glued at least
once before I bought it, and my avionics shop had glued it back together...
|
|
5 |
1,446 |
|
|
Oxygen- EasyPulse 5 conserving regulator? by
Dan Youngquist
Hi all,
I'd like to hear from anyone who has used the EasyPulse 5 while flying,
and can confirm whether it works at 12K-18K altitudes. Trying to put
together a good but low-buck oxygen system.
-Dan
( 1 2)
|
|
14 |
1,445 |
|
|
|
|
0 |
1,445 |
|
|
Flying into Canada by
Don Tuite
Documentation:
From the EAA: "The US and Canada have agreed not to require US or
Canadian pilots to have a restricted radio-telephone license or an
Aircraft Radio Station...
|
|
2 |
1,445 |
|
|
Two ILS approaches in IMC with ATC communications - Video by
A Lieberma[_2_]
Yesterday was a great day for knocking out approaches. Had stopped in
flight school to socialize before flying and CFI was bored to tears
since he had to cancel VFR students, so he came along for the ride.
Launched into 1000 foot ceilings and ceilings at Hawkins Jackson KHKS
was 1200 foot. KJAN...
|
|
1 |
1,444 |
|
|
1947 Fairchild project value by
dmoon
does someone have a clue what the value of a project basket for a 1947
Fairchild 24 R 46 with new factory engine. Project was purchased as is
and been hangered since 1995 never touched. My husband passed away in
September and I need to sell it so that I can sell the hanger and a V35
Bonanza. If...
|
|
3 |
1,444 |
|
|
Jeppesen USB Skybound Faster? by
Marco Leon
I don't think anyone has commented about this on Usenet yet (or at least
Google doesn't have it) so I'll put the question out there. Can anyone
confirm that the USB Skybound datawriter is faster than the PCMCIA Skybound
II? I am contemplating getting it for the slight convenience factor of using
my...
|
September 18th 04 03:49 AM
by GFC
|
9 |
1,442 |
|
|
Someone wanting to use our plane for thier commercial multi ticket by
Scott D.
My boss, who I fly for and am office manager for, personally ownes a
Seneca II. He had someone come up to him and asked him if he could
use the plane to get his commercial multi since there was no other
multi in the immediate area to do this in. I am also an MEI so my
boss told him that he would...
( 1 2)
|
|
16 |
1,442 |
|
|
ASOS by
PaulaJay1
Many ASOS frequencies in the Ohio area are being changed to the same
frequency(121.425). I find this bad since I usually tune in my local ASOS from
50 to 100 miles out (depending on altitude). This was fine when the
frequencies were different, but now I get info from a nearer one. I want to
know...
|
|
0 |
1,442 |
|
|
My P-47 was damaged while fighting by
Keith J. Crapper
My P-47 was badly damaged fighting off some enemy Zeros , can anyone
give me advice to repair it before the enemy attacks again?
( 1 2)
|
|
11 |
1,442 |
|
|
Q re Instrument lighting upgrade by Aero Enhancement: anyone with experience? by
Andrew Gideon
The club to which I belong is upgrading the instrument lighting in one of
our 182s. I've been doing the research side of this.
All was going well. We ultimately decided upon the panel overlay product
from Aero Enhancement, and started looking at shops to do the installation.
And here's where I...
|
|
5 |
1,442 |
|
|
Carb heat shroud by
Gene Seibel
I need a carb heat shroud/muff for a Cherokee 180. Salvage yards say
theirs are all cracked. Anyone know of a good source?
--
Gene Seibel
Hangar 131 - http://pad39a.com/gene/plane.html
Because I fly, I envy no one.
|
|
3 |
1,442 |
|
|
|
July 6th 03 11:23 PM
by Dave
|
0 |
1,442 |
|
|
auxiliary heat by
Jim Burns
Does anyone in the group use a 12v auxiliary heater or heated blanket for
added cabin or passenger heat? I've seen that they come in 150watt/12.5 amp
and 300watt/ 30amp versions. We'd have to figure out the current load on
our alternators but I'm wondering if we should even consider such an...
( 1 2)
|
|
15 |
1,441 |
|
|
Rough Engine, please help by
John Clonts
The IO-520 in my Cessna 210 is running rough. It seems to run smooth
at 1000 rpm but the roughness appears above about 1400. One cylinder
is “cold” and apparently not producing any power. I
pulled the rocker cover and found that the intake valve spring was
broken. My mechanic and I...
( 1 2)
|
|
14 |
1,441 |
|
|
Tie-down winter hazards by
[email protected]
We had 5-6 inches of snow last Thursday followed with a mix of
rain/freezing rain on Saturday. We went to the airport on Sunday
arming with shovels, snow brushes, isopropyl alcohol sprayer etc. Right
after entering the gate, we glanced at the ramp and was alarmed to see
the other Cardinal on the...
|
|
6 |
1,441 |
|
|
I'm Going In... Radio Saga Continued... by
three-eight-hotel
I've posted twice before on the problems I have been having with my
Narco radio's:
http://groups.google.com/group/rec.aviation.owning/browse_frm/thread/981307ec4df68cc6
I've decided that I'm going to pull the radio and the connector tray
and run new coax from the radio to the antenna, after...
( 1 2 3 ... Last Page)
|
|
32 |
1,441 |
|
|
PS Engineering by
Hankal
So many times we hear of poor service from some our supplies.
This is the time to tell about excellent service and immediate turn around.
My problem was with my intercom from PS Engineering. I had a constant noise in
my headset. After one phone call and an email I sent the unit to PS Engineering
on...
|
December 5th 03 12:25 AM
by Hankal
|
0 |
1,441 |