"Dennis" wrote in message ... If anyone cares to see a few hundred Oshkosh photo's, I put them on my site.. http://www.MyAirplane.com/oshkosh2003 And if you want to see last years photo's ...

I'm talking about where the prop stops when I shut down the engine. What would cause a 2-blade, constant speed prop on a Lyc. O-360 to suddenly begin stopping in a different position than it had every time for the last 3 years? My prop has always stopped parallel to the pavement until last night,...

Any advice on how to change a nav light on/off switch. It's attached to the roller knob that also controls the panel lights. I don't see any obvious way to remove it from the front, and the back is not easy to get a look at while lying next to the rudder pedals. I can get the lights to come on...

I just had a VFR Cert. done and the avionics shop said that the antenna of coax was causting the frequency of the transponder to be out of limits. Of coarse they had to bench adjust the frequency of the transponder to compensate. Has anyone ever had this problem before? Thanks, Ray

Need critics - new European general aviation website --------------------- Hi all! I would like to invite you to provide some feedback on the new European general aviation website. Currently we offer the following information: - aircraft sales (free classified ads) - flight training in several...

Does anyone know if there is an STC for use of auto fuel in a PA32-260. I've been unable to find one. At $3.30/gal for avgas at KBHM I've got to stop the bleeding a bit. Thanks in advance. Bruce McFadden Birmingham, AL PA32-260 N5594J

i saw you msg re the Cessna 337. What is the big expense for the 337 over similar twins? thanks, jeff *** Sent via http://www.automationtools.com *** Add a newsgroup interface to your website today.

Back in December I posed a question about replacing the fuel cut-off valve in my 47 Tcraft with parts from HDepot. There followed heated discussion. The outcome was we repaired the valve and re-installed it. I don't have a lot of confidence that this will last 10 years, so the issue is still open...

http://www.youtube.com/watch?v=qeNNULCL4Mw I was to go with a friend as I had not flown with him since he getting his PPL Winds were above his Xwind limits so I told him grab a CFI to experience what I considered rather mild crosswinds. I told him I wouldn't be comfortable from the right seat...

I realize that lots of theories may exist, and trouble shooting is a crap shoot from afar but I am wondering, what would cause a full discharge indication when I put my landing light on. This started shortly b4 I had my radio put in, and when I flew it back from the avionics shop, on the short...

Help - anybody out there experienced using the serial (not gray code) encoder inputs on a Garmin GTX 327? My manual (revision J) shows the first "RS-232 in" connection on Pin 19, in most places in the manual. But on on the encoder hook up chart (chart 2.6.2.1, page 15) it shows Pin 19 to be the...

Day 43 (Big Box #2) Put the plastic back in the plane. Looks a bit too bright when compared to the hat shelf. The Kiwi job on the headliner made it look MUCH better. Removed the stains, however, the plastic is still a bit whiter. Not too objectionable. The plastic also looks out of place because...

Apparently the preferred way to bond brake linings in Shinn brakes is to use rivets. I got my a/c with the linings epoxied(?)in place. 1. Is one fastening method prefered over the other? 2. Can I use heat to remove the current linings? 3. Any particular epoxy to use? Any danger of the lining...

Despite using windshield cleaning spray and lint-free, cloth wipes designed to clean aircraft windshields, I may have scratched my windshield in several spots. Not large scratches, but these appear to be those small ones that will show up when the sun shines through. Damn! It was a relatively...

I'm looking at a certificated aircraft for purchase. One thing I noticed was that the "normal" engraved metal manufacturer's data plate that's usually located under the horizontal stabilizer is missing. In its place is an engraved plastic plate with the serial number, model number, etc - the kind...

Anybody else have this great GPS? I just got the new updates with private airports and all, but it keeps crashing. I also was hoping to add weather to it somehow.

We had our archer II painted in 1996, including a clearcoat. About 6 - 12 months ago the clear coat started peeling just a little, almost exclusively on the control surfaces. (They were removed and painted separately, so it makes sense they behaved slightly differently. Now though, the clear...

Using this flight planner has become a regular part of my preflight prep. My membership expires at the end of this month. I sent in my renewal about a week ago. I noticed on Thursday I had lost access to the flight planner application just after getting a renewal reminder pop-up and I still...

PHOTOS: N14 - August 21, 2008 Kathy Jaffe Challenge (Aerobatics) Photos Link: http://phlairline.com/spotter/082108.html Cheers, DV

I have this plane full equipo ... so beatiful I have a Friend Angar in USA , Someone could help me what kind of Tax . I have to pay ... to reexport to USA , I think ...nothing because .. It is an american Plane ... but maybe I am wrong Some one could Help me ..!!!! Pls email me back Javier...