George A. Graham wrote:
On 25 Dec 2003, Ben Haas wrote:


So George, fill us all in on how you took a 5 speed trans and used it
to transmit 500-600 pounds of thrust from the prop when in a car there
is no thrust loads on the output shaft at all??




Sure Ben, Single deep groove bearings, and it is more like 300 lbs.
The stock output shaft is not used (too long).

George Graham
RX-7 Powered Graham-EZ, N4449E
Homepage http://bfn.org/~ca266


George, the last I heard, you had some teething pains with that
transmission PSRU and got some busted gears. I have to assume that is
all cleared up, but what is a 'single deep groove bearing'?

--
http://www.ernest.isa-geek.org/
"Ignorance is mankinds normal state,
alleviated by information and experience."
Veeduber