On Fri, 16 Jan 2004 08:41:07 -0800, Jim Weir wrote:

Does anybody have an idea on how to make a tiny little vacuum pump on the
order
of an aquarium pump or so that will draw just a few inches of water?
Preferably
110, but I can rig up a 12 volt supply if necessary.

The reason I say this is that I'm getting ready to pack a fairly large
number of
bags with used but serviceable engine parts (valves, pistons, etc.) and
I'd like
to put each part in a "baggie" (sandwich bag or equivalent) along with a
little
preservative oil, and then suck the baggie down with a football needle
stuck
into the top closing mechanism just before sealing.

Thoughts?

Harborfreight to the rescue again!

http://www.harborfreight.com/cpi/cta...temnumber=3952


Rich S.