I got that from the avionics shop that installed my 330. They have
written instruction to NOT program the assigned code, but instead
program the tail number into the 330. (I saw the instructions).

On 20 Apr 2004 08:48:53 -0700, Javier Henderson
wrote:

writes:

At this point, it doesn't do anything more than mode C.

The assigned mode S code is currently not being programmed into the
transponder, and the controller still doesn't get your tail number
until you give it to him.

Where did you get that? Programming the FAA assigned mode S code was
part of my installation, and I'm told part of every GTX330 installation
at the shop I went (Avionics West).

-jav