"Orval Fairbairn" wrote in message
news
In article ,
Greg Copeland wrote:

I'm just curious about rebuilding an aircraft engine. If you can
rebuild
automotive engines, will an aircraft engine be a no brainer? Are
special
tools often required?

Does anyone know of any good websites that do a walk through of the
process. Not that I'm planning on doing it, let alone via website
instructions, but I am intersted in learned more about the process and
the
associated costs. In the, "O-320 Engine Costs - 172", thread, I see
some
costs were fairly well layed out. Information like like that, helps
fuel
the dream of ownership one day, by allowing us to better understand the
complete lifecycle costs associated with ownership.


Thanks,

Greg Copeland


You really need the Lycoming Overhaul Manual, which lists tolerances,
torques, etc. for all Lycoming opposed engines. Then get to be friends
with an A&P mechanic, who is willing to supervise your work.

Some work is best farmed out, like cams, crank regrinding and checking,
etc.

Agreed.

In addition, once you buy all the little yellow tags that come with
inspected and "guaranteed to meet the spec" parts, the assembly of a
Lycoming is relatively simple. Probably a two evening job for you and
someone who's done it before and will be comfortable looking over your
shoulder and signing paperwork. On the other hand, once you've bought all
the little yellow tags, having a professional assemble the thing for you
only adds about $500 to the cost.

It probably takes an A/P more time to box all the re-certifiable parts, ship
'em, and deal with the engine part shops than it would take him to rebuild
the engine. He's gonna charge you for that time too. The thing is, he
probably gets a discount from the engine part shops and his $500 in
time/labor for dealing with the shops is probably a wash to you if he passes
along his discount from the engine part shops.

Installing the rebuilt engine is actually more work than assembling it.
You've gotta fix/fit baffles, install (replace/repair?) an exhaust, attach
(rebuild?) the carb, plumb the carb, attach (replace?) push-pull's, install
(overhaul/replace?) and time the mag's, install the starter, plumb an oil
cooler, etc, etc, etc... Then you get to attach the prop, run it up, check
for leaks (you did add oil, right?), and re-cowl it.

Beating a dead horse here, but the actual assembling of the engine isn't the
hard part, nor does it consume very much time in the scheme of things.

KB