Thread
:
Oil analysis after new cylinder breakin
View Single Post
#
6
November 15th 04, 04:37 PM
TripFarmer
external usenet poster
Posts: n/a
Yes we have a filter. Still can't figure out the reason for higher
tin levels.
Trip
In article ,
says...
Do you have a full flow oil filter (I hope so!)? Otherwise break-in
steel from the cylinders could be scratching in the bearings.
I would think it strange that a bearing would fail just because you
changed one or more cylinders. Increased loading from new jugs sure
isn't going to cause it.
TripFarmer