"Maule Driver" wrote in message
.com...

Interesting question. Without trying to look it up, I would say that it
is
your responsibility to remain clear or make contact with Mc Entire Tower
when VFR.


No. It is the responsibility of the radar controller to coordinate the
transition of Class D airspace.


FAA Order 7110.65N Air traffic Control

Chapter 2. General Control

Section 1. General

2-1-16. SURFACE AREAS

a. Coordinate with the appropriate nonapproach control tower on an
individual aircraft basis before issuing a clearance which would require
flight within a surface area for which the tower has responsibility unless
otherwise specified in a letter of agreement.

REFERENCE-
FAAO 7210.3, Letters of Agreement, Para 4-3-1.
14 CFR Section 91.127, Operating on or in the Vicinity of an Airport in
Class E Airspace.
P/CG Term- Surface Area.

b. Coordinate with the appropriate control tower for transit authorization
when you are providing radar traffic advisory service to an aircraft that
will enter another facility's airspace.

NOTE-
The pilot is not expected to obtain his/her own authorization through each
area when in contact with a radar facility.

c. Transfer communications to the appropriate facility, if required, prior
to operation within a surface area for which the tower has responsibility.

REFERENCE-
FAAO 7110.65, Radio Communications Transfer, Para 2-1-17.
FAAO 7110.65, Surface Area Restrictions, Para 3-1-11.
FAAO 7110.65, Application, Para 7-6-1.
14 CFR Section 91.129, Operations in Class D Airspace.



You don't have a clearance of any sort so your path of flight as well as
altitude is at your discretion. If you are in Class B,C,D, then the
controller can give you vectors and altitudes but doesn't necessarily have
to under FF.


The radar controller can issue vectors to VFR aircraft in Class B and Class
C airspace, but not in Class D airspace unless it is also a TRSA.