This unit was at one time installed in my plane before I owned it.
When they installed a "new" panel, they elected not to re-install it.

They took out the receiver, head, loop & sense antennas.

They left the tray, wiring from the tray, sense snub fir the sense
antenna at the top, loop antenna connector & wire at the bottom. The
three devices taken out were sent to an avionics shop to be checked
out.

I was under the assumption (stupid me), that all I had to do was slide
the receiver in the tray, reattach the loop antenna, replace the sense
antenna, and plug in the head....

Perhaps the damn thing read 180 out of phase the whole time????



dp