(Ben Jackson)
shared these priceless pearls of wisdom:

-
-It mentions in one sentence near the end (last column) that he threaded
-it, and warns to get the bolts tight before you start whacking them with
-a hammer and ruining the threads.

Got it. Completely missed that sentence. Am I reading that right? That he
actually EXPECTS the exposed rod threads to peen over against the top nut? I
sort of would like to be able to disassemble it because I'm sure that the
flatwasher (or is that a lockwasher?) is going to bend and break after a couple
of dozen uses. Or, I could simply hacksaw the threaded part off and rethread
it. I doubt 18" is going to hold much tighter than 17".


Jim



Jim Weir (A&P/IA, CFI, & other good alphabet soup)
VP Eng RST Pres. Cyberchapter EAA Tech. Counselor
http://www.rst-engr.com