This what I was always told, but when in doubt, verify with the controller.

Harvey

"Judah" wrote in message
...
The reg seems to support the statement that the "Taxi To" instruction
permits you to taxi across ALL other runways, even if they are active. It
only prohibits you from actually entering or crossing the one runway to
which you are assigned (ie: taxiing to)...


"Steven P. McNicoll" wrote in
ink.net:


"Dan Luke" wrote in message
...

Then I've committed an awful lot of runway incursions without
ever being told about it.


Well, you have if you crossed the assigned runway. If you merely
crossed other active runways that were not assigned to you then you're
okay.


§ 91.129 Operations in Class D airspace.

(i) Takeoff, landing, taxi clearance. No person may, at any airport
with an operating control tower, operate an aircraft on a runway or
taxiway, or take off or land an aircraft, unless an appropriate
clearance is received from ATC. A clearance to "taxi to" the takeoff
runway assigned to the aircraft is not a clearance to cross that
assigned takeoff runway, or to taxi on that runway at any point, but is
a clearance to cross other runways that intersect the taxi route to
that assigned takeoff runway. A clearance to "taxi to" any point other
than an assigned takeoff runway is clearance to cross all runways that
intersect the taxi route to that point.