It's annual time on the starduster, and several of the screw holds
to hold on the inspection plates have been enlarged over the years to
the point where a screw won't stay in the whole. Around each inspection
hole, there is a thickened area in the fabric that has been drilled
or punched to recieve the screws. We are using sheet metal screws.
I don't know what covering system was used, but could probably find
out (it was recovered several years before I bought into the
partnetship). Is there some kind of filler that could be placed in
these holes and then drilled out back to a smaller size so that the
screws would stay in?

Thanks in advance for any ideas.

Brian Huffaker, DSWL )
RV-8A 80091 Riviting foward lower fuseage skin
1/4 Starduster Too N23UT flying.