One would not simply bolt a prop to a pump shaft... you will need to
add a suitable bearing and hub assembly which will surely weigh some
pounds.

Sid Knox

"PAW" wrote in message ...
This is a BS question, but I'm curious.

I was looking at some hydraulic motors the other day and was wondering if
a pump and motor could be used to drive a prop. A crazy example; two
hydraulic motors and a couple pumps (powered with a mazda 13b maybe ??) to
power something like a Cessna 337 in-line thrust type aircraft.
Understanding weight would be an issue, I'm wondering how it would, or could
,work. I was looking at an Eaton motor that was rated at (up to) 3200 RPM @
about 120 ft. lb of torque. Weight was 20 lbs. They have a pump (48 lbs)
that moves 42 gpm @ 4000 psi.

Is it possible? Single place would be fine.