The fields cannot cause a problem during startup since the alternators are
turned on after the engine starts.

-Ali

"Dan Thomas" wrote in message
m...
"Ali Ghorashi" wrote in message
...
Hello All,
The manufacturer of the alternators in the Cessna 310 that I fly requires
the pilot to turn off the alternators before engine shutdown. Failure to
do
this will void the warranty on the alternators. Does anyone know of a
reason
for this? I have a suspicion that it has to do with the fact that with
one
engine shutdown, the alternator's field on that engine can be energized
by
the other engine's alternator. This may cause problems if the battery is
low
(i.e reverse bias some diodes/transistors). That's just a WAG. Any ideas?

-Ali

The alternator's field current is controlled by the regulator,
and when it's on but not turning the field gets pretty much full
battery voltage. That voltage would be a bit higher than normal if the
other alternator is running, but not dangerously so. The field can
take it.
The danger, as I see it, is either that the field of the
alternator on the dead engine can get hot after a while if it's not
spinning and could burn out (the fan isn't cooling it) or that the
pilot may forget to make sure the alterators are off before starting
the engines next time. Two fields can suck up enough current to make
starting an engine that much harder.

Dan