Mark Zivley wrote in message om...
Take a small knife and carefully pry the very end of the knob off. The
seam may be hard to see, but there is a cap on the foremost portion of
the knob. Once you get the cap loose that will expose a screw down
inside the knob. Tighten that up and it will probably fix your problem.
No need to dig farther or even remove the unit from the panel.
Careful that the cap is small and can get away from you!


I don't think you read what he said. Sorry it's going to be opened up
and that will require factory or dealer re-seal.


Andy