Thanks!

"Mark Zivley" wrote in message
om...
That is a very nice 1-26.

Jim Phoenix wrote:
For an aluminum vertical stab, see the photos at the bootom of this page:
http://www.jimphoenix.com/jimphoenix...empennage.html

For a cloth covered vertical, see the photos here for an internal
installation (seventh and 8th photos from the top of the page):
http://www.jimphoenix.com/jimphoenix...empennage.html

As Dave said, the Ilec probe is very nice, the short length will do for a
1-26. I have a plenty of that aluminum tube installed in the fabric
vertical if you need a piece Heinz. I also have the rivnuts and stuff for
the aluminum vertical, if I recall - that's the vertical 442 has.

Jim


"Heinz Gehlhaar" wrote in message
...

I am thinking about installing a TE-Probe in our Club
1-26D, S/N 442
Is there any advice you can give me about where to
locate the probe? Think about: mounting-spot for accuracy,
versus for ease of installation and for minimum additional
weight.

Also, what type of probe and sources of the probe and
the interfacing fittings/materials would be helpful.

Thanks
Heinz