On 3 Jan 2005 02:45:47 -0800, (khanindra jyoti deka)
wrote:

Hi,
I am doing doing an Embedded Design course.Here i get "Advanced fuel
flow mesurement system using microcontroller" as a project topic.But i
dont know much about the topic.How to measure the fuel.
Anybody who did/doing some work on it please help me out of this
problem.
I need the guidence to start it.If anybody guide me i will be grateful
to him.

Regards
Khanindra j. Deka

dont quote me on this. I used to teach in a peripheral system.

aperture plate in the line with pressure transducers upstream and down
stream of the plate.
PID (proportional, integral and derivative) loop in the
PLC.(programmable logic controller)
senses the pressure differences and integrates a function which
assumes a flow rate equated to a pressure difference.
uses the computed flow rate to derive the control output.

hunt out some of the PLC manufacturers web pages. these may give you
more info on PLC setups.
Allen-Bradley
Texas Instruments
Omron
Square D (an old one)
Honeywell
....are just a few PLC manufacturers that come to mind.

hope this gets you started.
Stealth Pilot