Steve wrote:

This can be a problem, but is easily avoided. My web site shows an
injection technique that I used when I started. Since I have changed my
infusion strategies. However, the feeder line as you see it could leave a
lump or impression in the surface. The way I do it now, there is no
problems. Check my web site again in a week or so, as I plan on updating it
soon with some new pictures.


I've got it bookmarked and will keep checking back. The wings of the
Delta are fiberglass, and are laid up on a flat surface and then mated
to the ribs. You basically have an 8'x8' triangle that has to be wetted
out at once. A technique that could eliminate the hurry and provide
better results would be a godsend.

Do you have any problems with pinholes?
--
----Because I can----
http://www.ernest.isa-geek.org/
------------------------