: Being an A&P, I simply made a log book entry using the Piper conversion kit
: number (gasp) since I was pretty sure nobody had ever seen the real Piper
: conversion yokes and so far nobody has said a word about it.

Couldn't you simply call this an "owner fabricated part?" Granted, there's a
lot of misinformation on this subject, but the A&P is ultimately responsible for
determining what an "equivalent" part is. IIRC there's no requirement to have
drawings, procedures, etc, etc to replace a factory part... just so long as it is
"equivalent."

Thoughts?

-Cory



--

************************************************** ***********************
* Cory Papenfuss *
* Electrical Engineering candidate Ph.D. graduate student *
* Virginia Polytechnic Institute and State University *
************************************************** ***********************