The 302 has no facility for the user to perform airspeed
adjustment for static errors. On the gound in zero
wind my 302 airspeed often showed several knots of
positive reading. These 2 aspects perturbed me when
I had a 302 and as there was no information in the
manual I asked Cambridge and was told that it did some
self calibration thing when it flew and that in the
air the 302 airspeed reading should be accurate - which
turned out to be true. So checking what your 302 reads
on the ground is not going to give you much information
about your problem. On the other hand if you put the
302 and your ASI on the bench and give them some shared
pressure to the pitot inputs and compare readings you
might learn something.

Errors as large as described seem excessive for positional
static errors even if the ASI and 302 are on different
statics so that would suggest either a pneumatic tube
problem or a sensor problem. The bench test would
give you an idea of which and if it looks like the
302 sensor is duff you could contact Gary Kammerer
at Cambridge for advice.

)

John Galloway


At 00:12 15 August 2005, Bob Fidler wrote:
Start by checking the setup calibration numbers listed
in the manual. Maybe
zero airspeed is wrong, therefore every speed is off
by that amount.
'Ross Biggar' wrote in message
...
I fly a Ventus CT with a Cambridge 302 and an Ipaq
using Winpilot.
Flying yesterday I checked the IAS shown on the 302,
I noticed that it is
giving
totally different readings to the mechanical ASI.
eg at 50kts on the mechanical, the 302 showed 40kts
at 70kts the 302 showed 63 kts.
I did not check at higher speeds to see if the difference
reduced further.
I am reasonably sure the mechanical ASI is probably
correct, (if it was
10kts out on finals
it would be an interesting approach) !!.
I checked the IAS as I have been doubting the wind
shown on Winpilot, if
it is using the IAS fron the 302
and that is in error, then that would explain the
wind problem.

Does anyone have any suggestions as to what can cause
such a difference
betwen the mechanical
ASI and the 302??
Thanks
Ross