Eric Miller wrote:
A GE Minigun. :^) Well, it IS a tool...


It dimples at the same time as it drills... 8 holes per sec!

And if you make a mistake while fabricating a part, I can't think of a
better way of venting frustration.

If only it shot clecoes and deburred at the same time.
Finding correct rivets is tough though... and hand squeezing them is out of
the question :-)

Ah, but the proverbial glass is actually half-full. You could yet
corner a niche market--right now nobody makes 7.62mm rivets or clecoes!