John Doe wrote:
I am getting bleed through on my intercom when my strobes are on.

Has anyone else had to deal with this? (Drives my wife nuts at night)

Not a huge problem to overcome, but it can be a persnickity one...

Make sure the strobe power supply is properly grounded (if it has a
central supply) Also make sure that only one end of the shield is
grounded if it uses shielded wire.

Check to see that the strobe wiring is kept as far from the radio
wiring as possible and that if it has to cross some, make the cross as
close to a right angle as possible.

If it's the type system with the power supplies at the stobes, make
sure the grounds are good.

If none of this solves the problem, then you are going to have to start
digging into the radio/intercom wiring next, and that can get
complicated real quick.

You might also check out Jim Weir's pages over at www.rst.com (?) for
more suggestions if you are still having problems. I'm not sure what
all he has up over there these days, but he is a wealth of info on
radios and intercoms.

Craig C.