View Single Post
  #23  
Old June 20th 06, 09:58 PM posted to rec.aviation.homebuilt
external usenet poster
 
Posts: n/a
Default O/A welding question: tip size

"mhorowit" wrote in message
ups.com...

Capt. Geoffrey Thorpe wrote:
But it sounds like, in spite of what your chart says,
you need to use a smaller tip. Just be sure you are getting enough of a
puddle on the sleeve as you turn down the heat.


Someone in the office suggests if I go to a much smaller tip, then the
area I'm heating will be smaller and therefore I may be introducing
stresses closer to the work.
Is that a consideration in the world of 4130? - Mike


That's news to me...

--
Geoff
The Sea Hawk at Wow Way d0t Com
remove spaces and make the obvious substitutions to reply by mail
When immigration is outlawed, only outlaws will immigrate.