Many are balanced pressure so 5 psi and 5psi might do the job,


"Morgans" wrote in message
...

"Ken Moffett" wrote

32psi? That sounds more like "cutting tip" O2 pressure, not welding.

Yeah, you're right, it is. My mistake.

Ever try to weld with a cutting tip? Not easy, but it can be done! g I
wouldn't try to weld an airplane with a cutting torch, though.

Quite frankly, I do so little gas welding, I just play with it, until I
like it. I don't remember what I use. Does around 12 pounds sound about
right? That's what seems to come to mind.

Still, 2 pounds is not very much. I tend to use the knobs on the torch to
control the flow, as the most important control. I would think that if
you were using two pounds, you would have to have the knobs all of the way
open. I would think it would be hard to keep a consistent flame, like
that.
--
Jim in NC