"Paul Tomblin" wrote in message
...
I was doing my BFR last night in my club's Piper Lance (in case you're not
familiar: it has retractable gear and a IO-540 fuel injected engine). We
finished up with a bunch of touch and goes, demonstrating short, soft,
etc. The last landing, the instructor pulled the throttle and had me do a
forced landing. I had no trouble making the runway, and rolled off the
runway and over the hold short line. As I was tuning the ground frequency
on the radio, the engine died. And I was unable to restart it and neither
was the instructor - I ended up having to call the FBO to tow me back to
the tie down line.

It wasn't until some hours later that it hit me - during the forced
approach, I had the throttle at idle, the mixture at rich and the boost
pump on. Which is exactly how you prime it for a cold start - except for
starting you only do it for about 3 seconds, and this was for the whole
duration of the forced approach. So I figure I probably flooded it. So
what's the answer? Do you turn off the boost pump when doing practice
forced approaches? What about normal approaches?

Boost pump only during normal ops/normal throttle.

Does that mean turning
on the boost pump has to become a normal action on go-arounds and touch
and goes?

What does the POM say?