"Kyle Boatright" wrote in message
. ..
I'm working on the center section for a Hatz. The trailing edge of the
center section is a recurved lamination that provides better access to the
front cockpit.

I've steamed and clamped the strips into a form, and they have taken on
some of the curve, but when I unclamp 'em after they dry, I get
significant springback. The question is whether I need to allow for this
in the finished lamination, or whether the springback will go away when I
glue up the assembly?

FYI, the lamination starts as four 3" x 1/4" strips.

Thanks in advance,

Kyle Boatright

Never mind.

This was supposed to go to R.A. Homebuilt...