On 24 Jan, 00:29, "Kyle Boatright" wrote:
I'm working on the center section for a Hatz. *The trailing edge of the
center section is a recurved lamination that provides better access to the
front cockpit.

I've steamed and clamped the strips into a form, and they have taken on some
of the curve, but when I unclamp 'em after they dry, I get significant
springback. *The question is whether I need to allow for this in the
finished lamination, or whether the springback will go away when I glue up
the assembly?

FYI, the lamination starts as four 3" x 1/4" strips.

Thanks in advance,


Just did my first laminations a few months ago. They didn't spring at
all once they were glued up.


Bertie