"Larry Dighera" wrote in message
...
On Sun, 27 Jan 2008 06:39:21 -0800, "NW_Pilot"
wrote in
:

1/2' Foam

Are you planning on bolting the aluminum base-plate to the Pelican
case, or just letting it float against the foam?

With the fan oriented to exhaust the hot air from the interior of the
case, I can see where two supply-air registers might be cut into the
sides of the case, one on either side near the handle-end. But I have
a feeling you've already considered the cooling issue carefully.


Yea, the aluminum plate will be secured to the case Iwant to wait till i
have all required connectors in before drilling any other holes