On May 23, 8:44 pm, Nick Kennedy wrote:
Does anyone out there know how to get the water ballast tanks caps off/open
to fill? They have a 1/8 inch hole in them to spin the around, but several
us have tried to get them off/open but no luck..
TIA
Nick Kennedy

If it's the same cap as a single Astir, which I have.

I use a L shaped piece of coat hanger wire to lift the cap out. I
then tape the plug down, making sure that the hole is not covered.

If it's the same system as the G102, then there is no valve in the
wing and there is a pipe in the wing that fits into the fuselage (with
a Volkswagen shaft seal) and a dump valve in the fuselage. This
means that the water will cross fill between wings and you have to
keep them level before launch.

Todd Smith