Tri-Pacer wrote:
I have a Narco MK-12D+ that has an intermittent connection in the display
assembly. At times the display will go dim---it never goes completely
out-----. Pressing lightly anywhere on the front panel returns it to normal
brilliance.

This pretty well isolates the problem to either the display itself or the
dimmer circuit.

My question is this. Is anyone familiar with the inner workings of the
MK-12D+. Is the display hard soldered in or is it on a subassembly that is
in some way socketed.

I have seen the innards of some of the older Narco stuff where they used a
lot of plugs, ribbon cable and sockets to connect subassemblies together.
If this is the case with the MK-12, I might luck out and just have a
connection problem. If it's all surface mount stuff then I guess I'm gonna
have to cough up some AMU's .

Cheers:

Paul
N1431A
KSDM


I just bought a 12D+ when my 12D went belly up. Narco has been good at
factory repairs with me and not too bad on $$$. Both 12Ds and my audio
panel had to go back over the last several years. They were getting very
old.

--

Regards, Ross
C-172F 180HP
KSWI