On Jan 28, 11:50*pm, Uncle Fuzzy wrote:
In going over some very old (15 years) RAS threads on gear collapse
problems, I found a reference to a service bulletin that mandates
replacing the gas spring with an aluminum bar. *JJ also mentioned
doing the same. Alas, the 15 year old link is inoperative. *On the DG
website I found a listing of service bulletins, but not the service
bulletin itself. *If anyone can send me a link or explain how to
obtain the reference service bulletin, I'd be very grateful.
TIA

Good points below, but a friend who just repaired the
following on his LS-3 reminds me...

Many of these LS gliders have rubber shock absorbing
gizmos built into the landing gear - and they are now getting
very old and turning to mush. The glider will typically sit much
lower to the ground then when new (and has less shock
absorption, wrong angle of attack on ground etc).

If the strut wasn't recently replaced, you'll want to have
a good look at that part as well !

Hope this helps,
Best Regards, Dave "YO electric"