Ed wrote:
On Mon, 11 May 2009 22:44:23 -0500, Brian Whatcott
wrote:

There is one central location that is not subject to prop blast,
exactly: - that's the nose cone of the prop.
Visualize a small hole set about an inch back from the front.
Use a local pressure sensor chip and a wireless transmitter.

The flow from off axis would module the air pressure slightly
one cycle per revolution, with amplitude in proportion to
AofA (maybe :-)

Brian W

The wiring might be a little tricky

A wireless chip to a fixed receiver chip is not a biggie. But getting
that sensor chip and transmitter chip inside the nose cone in dynamic
balance would be an issue, I reckon....

Brian W