Hi Frank,

I have seen that a few times. It normally goes away when I edit the
turnpoint sectors to reflect those used in the flight. To do that in
SeeYou, go to the Edit menu and select "Flight Properties". Then go to the
Observation Zone tab.

I think there are other tips to getting past the issue, but I don't remember
them at this moment. I'll think about it. It may have been other settings
in the Flight Properties windows.

Best Regards,

Paul Remde
Cumulus Soaring, Inc.

"Frank" wrote in message
...
I flew a TAT today at the Cordele, Ga USA contest, and as I always do
I opened my flight in SeeYou 3.95 for analysis. Except this time it
showed a 'photo landing' between the 2nd and 3rd turn areas, and there
seems to be no way to get rid of it. I have been using SeeYou for at
least 8 years, and am pretty familiar with the common sorts of task
declaration errors that can lead to this situation. However, this
time I can't get rid of it for the life of me.

I attempted to post this on the Naviter support forum, but that seems
to be screwed up too. I can't get an activation email, and since I
can't get an activation email, I can't complete the forum registration
and therefore can't post. I also looked at their forum postings about
'photo landings' and it seems that the SeeYou folks aren't really
interested in addressing this issue (assuming it *is* an issue and not
just something I'm doing wrong).

Anyone else had this problem with SeeYou 3.95?

Frank (TA)